If you're searching for a leader in reliable, quality restoration of Cross Ram carburetors, then look no further.

This specialty service transforms tired, worn-out O.E.M. Cross Ram back to their original condition. And because this is a "custom" service, each order is personally followed through from start to finish by a  factory technician.

Not only are Cross Ram carbs restored, but Rochesters, and Carters, too. Engineering parts lists are uncompromisingly followed to the letter. In some remote cases where an O.E. part may no longer exist, an O.E. "equivalent" is used in its place.

You can be assured that your carburetor will remain in good hands. Even before any work begins, two or three close-up photos are taken of each carb from different angles so that it can be easily identified at any time during its stay at the Shop. Many more precautions as well are taken to ensure your order stays together. Here are some other important reasons why the  Shop's restoration process stands out in customer satisfaction:

• Inspection of carbs for metal fatigue, slightly-stripped threads, hair-line cracks and worn-out throttle lever bushings.
• Cadmium Chromating of steel parts (clips, fasteners, linkages, etc.) for O.E. looks and corrosion protection.
• Chemical and vibratory cleaning of all carburetor castings.
• Testing of subassemblies-chokes, vacuum secondaries, float bowls, metering blocks-to verify performance before final assembly takes place.
• Replacement of gaskets, diaphragms, power valves and needle/seat assemblies.
• Flow-stand testing of all carburetors to confirm correct metering of air/fuel volumes.

Photo above shows the beautiful original carburetor color and inked inspection stamp.	Perfect example of correct original finishes and colorizations.  Fuel “Y” block shows original manufacturers broach marks and typical edge wearing of thin matte finish nickel plating.

Before a carb is sealed in a carton and returned, all paperwork is enclosed; this is your proof that the work was performed by Holley and that the carb has passed all of the factory's quality standards as prescribed by the O.E. manufacturer.

NOTE: Prices are based on rebuildable cores (no damaged castings, stripped threads or missing parts.) Damaged or missing parts will be repaired or replaced and a charge will be added based on replacement value. Contact the Rebuild Shop for specific price information.